7
PREPARATION FOR USE
Before you begin, locate and identify the components detailed in Figure 6. These components will be referred to throughout the “Installation” and
“Operating” procedures. Make sure you understand the function of each component before proceeding.
Items Required
1.
AC extension cord
Figure 5 Forklift Lift Points
Figure 6 Installation Components
Charger Power Cord
- All UniLifts are supplied with a recessed charger power cord. To access the cord grab the male end of the cord and
gently pull the power cord out of the recess. The cord will extend 2 to 3 inches to allow a 120 VAC extension cord to be attached. After charging,
disconnect the extension cord and push the plug back into the recess.
Universal Key Switch
- All UniLifts are supplied with a universal key/battery disconnect switch. Turning the key to the OFF position disconnects
all battery power from the UniLift. The key is attached to a lanyard and taped to the side of the mast. Remove the tape and insert the key into the
switch on the console.
Operator Console
– The UniLift’s operator console includes a key/battery disconnect switch, UP and DOWN controls, outrigger position LEDs and
battery charger LEDs.
