Bishamon BSC3200KU, Руководство по эксплуатации и обслуживанию

Страница: 17 / 23

ー 14 ー
10
Clean Up After Service Work
11
Regular Inspection
Check condition of rubber supporters after service work.
Keep them clean and free of oil and grease.
If any abnormality is found, contact your supplier.
For safety, turn off the circuit breaker.
Period
Every Month
Every 3 Months
Every 12 Months
Parts
Bolts, Screw
&Nuts etc.
Air Circuit
Lowering Stop
Device
Oil Tank
Control Box
Pipeline, Air
Hoseand parts
around them
Scissors Link
and Drive-on
Plates
Base
Lubricate the parts and points shown on page 16.
Hyd. Cylinder
Side Sill Block Side Sill Block crack, deforming
Oil Tank and
Synchronizing
Cylinder
※ Replace oil in 3 months after installation, then replace every year
Looseness
Joint, Air Tube,
Air Pressure Equipment
Movement of the Safety
Hook Release Cylinder
Electric components
(Magnet Switch, Relay
etc)
Wear of bearings
Rotation of Roller
Link and Drive-on Plates
Suction Filter
Joint
Pipe Line, Hyd. And Air Hoses
Oil Leak
Natural Lowering
Oil
Oil volume
Looseness of Anchor Bolt
Level Adjustment
Tightening
any leak of drain or air inside of
the circuit
movement, dirt at contact
point, crack
any leak of oil or air ⇒ tightening
any crack, oil leakage ⇒ replace parts
smooth movement of the parts
clog
leak from dust seal,joint
Lift up vehicle and check the
lowering( ≦1mm/5 Minutes )
looseness at bearing
offset wer at rollers
crack, twist, damage, distortion
Oil conditions
tightening and adjusting level
Items to be inspected Inspection Method
Esso
Unipower SQ32, XL32
Shell
Telus Oil 32, K32, W-R Oil32
Mobil
Mobil DTE24
Quality of Hyd. Oil is very important for the perfomance of the gear pump used for
the lift and the recommendable oil are as below or equivalent.
Viscosity - ISO VG32 Oil Volume - 13 litters
〈Hydraulic Oil〉