BIRO 1433FH, Руководство по эксплуатации и обслуживанию

Страница: 7 / 36

Item No. 16543 – Lower Shaft for Removable Wheel
6. The Model 1433 Lower Removable Wheel has been revised to include a keyway in the bore. Also an anti-rotation
pin is now pressed into the lower shaft to prevent any inadvertent "spinning" of the wheel on the shaft.
NOTE – If the saw in which a new shaft is to be
installed has a groove (keyway) in the bore of the
lower wheel, press the taper pin (provided "loose") into
the hole in the side of the shaft (see sketch).
If there is no groove (keyway) in the bore of the lower
wheel, discard the taper pin and use the shaft without
the pin.
7. The side platter bracket (Part No. S14214 ) is packed loose in the machine and must be installed on the left side
of the base structure with the supplied hardware and checked for proper adjustment. Stationary platter must be
flat.
8. Machine MUST be properly grounded. Use qualified electrician to install according to building codes.
WIRING MOTOR
(1) Interchange of motor current is made in motor outlet box. Leads are properly marked. Changing
instructions are on motor plate or inside junction box cover.
(2) All saws are wired 220 volts unless otherwise specified. Be sure motor specifications (voltage, cycle, phase)
match power supply line. Be sure line voltage is up to specification.
(3) Connect leads to machine in a manner that will be approved by local electrical inspectors.
(4) We recommend no less than No. 12 wire. If the leads are too light, machine may not have sufficient cutting
power and/or speed.
(5) The drive belt is packed loose in machine to prevent deformation, and must be installed on pulleys at time of
wiring motor.
(6) The BIRO Manufacturing Company is not responsible for permanent wiring, connection or installations.
9. All machines are tested at the factory, but electrical phasing for proper rotation may not match your electrical
supply. All machines with removable lower wheel must be first test run for proper phasing with the lower wheel
removed. Failure to remove the lower wheel could cause the wheel to become dislodged during testing.
All machines with removable lower wheel will display the following decal on the right hinged base door.
5
NOTE TO OWNER AND ELECTRICIAN: IF THIS MACHINE IS NOT CORD
AND PLUG CONNECTED TO THE ELECTRICAL SUPPLY SOURCE, THEN IT
SHOULD BE EQUIPPED WITH, OR CONNECTED TO, A LOCKABLE,
MANUALLY OPERATED DISCONNECT SWITCH (OSHA 1010.147).
28