BIRD SMK-3000 Series, Руководство пользователя

Страница: 25 / 44

Setup
15
Sensor RF Connections
Connect the end of the power sensor labeled “SOURCE” to the RF source. Connect the end labeled “LOAD” to the
load or antenna. Reversing these connections will cause measurement errors.
1. Disable the output of the RF Source, if required.
2. Connect the RF Power Sensor’s output connector to the load.
3. Connect the RF Power Sensor’s input connector to the RF source.
Figure 11 4421A Connections
WARNING
Never attempt to connect or disconnect RF equipment from the transmission line while RF
power is applied.
Leaking RF energy is a potential health hazard.
CAUTION
Do not exceed the RF Power or RF frequency specifications of the RF Power Sensor.