BIRD ACM500I M Series, Руководство по эксплуатации

Страница: 19 / 48

8
Chapter 3 Installation
This chapter provides information for preparing the Bird Antenna & Cable
Monitor for use.
Unpacking and Inspection
1. Carefully inspect the shipping container for signs of damage.
Note:
If damage is noticed, do not unpack the unit. Immediately
notify the shipping carrier and Bird Electronic Corporation.
2. If the shipping container is not damaged, unpack the unit.
Note:
Save the packing material in case the unit needs to be
shipped again.
3. Inspect all of the components for visible signs of damage.
Note:
Immediately notify the shipping carrier and Bird Electronic
Corporation of equipment damage or missing parts.
The Bird ACMI is shipped complete and ready for use upon receipt. After
unpacking and inspecting the unit, it is ready to be installed.
WARNING
Leaking RF energy is a potential health hazard. Never attempt to connect or
disconnect equipment from the transmission line while RF power is being
applied. Severe burns, electrical shock, or death can occur.
Mounting
Mount the ACMI in the feeder line between the combiner and the antenna.
Make sure that the alarm LED and reset button are accessible, and that the
connecting cables have proper clearance.
Cable Connections
Note:
Refer to
Figure 3 on page 9
for cable connections.
When connecting the Bird ACMI to RF power, use 50 ohm coaxial cable suitable
for the frequency and power level of operation. The cable connector should
mate with the connector on the unit.