Initialisation
2.5
Programming a transmitter to output 1
2.5.1
Notice:
The distance between the transmitter and receiver must be at least 1 m.
Up to 7 transmitters can be programmed for each output. Transmitters can be learned in with or without a connected detector / switch.For reasons of
safety, memory mode is exited automatically 10 seconds after the last key press.
Enter the memory function.
1. Press the key of the receiver until a
signal sounds
.
LED3
lights up
red for maximum 10 seconds (display memory readiness output 1).
The transmitter must be activated
within these 10 seconds
:
2. Press the key of the transmitter
until
a signal sounds
on the receiver
.
Other transmitters can now also be programmed by pressing their keys
Programming a transmitter to output 2
2.5.2
Enter the memory function.
1. Press the key of the receiver until a
signal sounds
. LED3
lights up
red.
2. Press the key again
until a signal sounds
.
LED3
flashes
red for maximum 10 seconds. (Display memory readiness output 2).
The transmitter must be activated
within these 10 seconds:
3. Press the key of the transmitter
until a signal sounds
on the receiver.
Other transmitters can now also be programmed by pressing their keys.
Finishing programming:
Wait 10 seconds until two signals sound.
Tip:
The transmitters for output 1 and the transmitters for output 2 can also be learned in without an interruption. After step 2.5.1 (programming the
transmitters for output 1, LED3 is permanently lit), the key of the receiver must be pressed within 10 seconds until a signal sounds. This means the
memory function goes directly to step 2.5.2 (LED3 flashes). Now the transmitters for output 2 can be learned by pressing the key (transmitter).
Reset: Delete transmitter memory
2.5.3
Enter the memory function
1. Press the key of the receiver until a
long signal sounds
. Signal sequence:
The transmitter memory is now deleted. After 10 seconds, two signals sound and memory mode is exited automatically.
Connecting the detector
2.6
Wire up the transmitter with a safety edge 8.2 kohm
Wire up the transmitter with contact (e.g. wicket door)
RFGate 2.1.S / 2.1.S.NC
RFGate 2.1.2.F
with NO contact, RFGate 2.1.S
with NO contact, RFGate 2.1.S.F
with NC contact, only RFGate2.1.S.NC
Function test
2.7
Connect the system to power. Press all safety edges one after another and check the behaviour of the receiver and/or controller is as required.
Cable diameter:
RFGate 2.1.S / RFGate 2.1.S.NC: 3 … 6,5mm;
RFGate 2.1.S.F: 3.5 … 5 mm
