8
Trouble shooting
Issue
Possible cause
Solution
– Increase the frontal angle of the radar module
– Install sensor higher and if possible directly above the door hinge
– Increase CTA level
– Rotate the sensor in the direction of the door opening
– Activate the interference suppression filter
– Activate the special filter function MTO
(Mass Traffic Optimization)
– Decrease the CTA level (switch off)
– Check field size
– Activate high mounting height
Refer to chapter
6.1.1
5.2.3
6.1.1
5.2.3
5.2.3
5.2.3
Door does not close / reverses
Door does not close / reverses
Door opens inadvertently
Door does not open –
random non-detection
of an individual
Late detection or
non-detection of persons
– Sensor sees sliding door
– Sensor sees swing door
– Interference source affects microwave field
(e.g. fluorescent tubes)
– Large group of persons
approaching
– Field too small
– Installation too high
7
7.1
Mechanical Settings of the Sensing Field
Frontal adjustment
7.2
Lateral adjustment
9
Technical Data
Technology
Transmitting frequency
Transmitting power
Operating voltage
Operating current
Mains frequency
Temperature range
Air humidity
Mounting height
Relay output
Switching voltage
Switching current
Switching capacity
Housing
Weight
Protection class
Minimum detection
speed
Cable length
Overview of countries
Microwave motion detector with
planar module technology
24.125 GHz
< 20 dBm
12–36 V DC / 12–28 V AC
approx. 50 mA @ 24 V DC, 75.2° F
50 Hz
–4° F to + 140° F
0 to 90 % rel., without condensation
up to 13.12 ft
Potential-free changeover contact
max. 48 V ACDC
max. 0.5 A AC / 1 A DC
max. 60 VA / 30 W
Cover: PC; floor plate: ABS
Dimensions (W x H x D):
6.93 x 2.44 x .20 inches
5.29 ounces (without cable)
Suitable for use acc. to IP 54
1.97 in/s (in sensor axis)
< 1.97 in/s with SMD+
(inclination angle 35°)
9.84 feet
EU; EFTA; US; CA
5°
45°
–30°
+30°
5°
45°
–30°
+30°
+ +
F
6
1
+
B
4
D
+ +
F
4
1
2
2
2
9
9
8
S
0
3
/1
7
If after troubleshooting a problem, a satisfactory
solution cannot be achieved, please call:
Bircher Reglomat
at 800- 252-1272
from 8am - 5pm central standard time.
You may also visit our website at:
www.bircherreglomat.com
DO NOT LEAVE ANY PROBLEMS UNRESOLVED
NEVER SACRIFICE SAFETY FOR ANY REASON
Bircher Reglomat reserves the right to change any information on this docu-
ment without notice.
For the latest version, please log on to www.bircherreglomat.com or call us
at 847-952-3730 to request a copy of the current version.
10
Contact
11
13
12
Disclaimer
FCC Approval
EC-Declaration of Conformity
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications made to this equipment not expressly
approved by Bircher Reglomat AG may void the FCC authorization to operate
this equipment.
4
Manufacturer:
Bircher Reglomat AG, Wiesengasse 20, CH-8222 Beringen
Importer:
Bircher America, Inc. 870 Pratt Ave N, Schaumburg, IL 60193, USA, www.bircherreglomat.com
Following directives have been observed: RoHS 2011/65/EU, RED 2014/53
Standards taken into account:
EN 300 440-1 V1.61:2010-8, EN 300 440-2 V41.41:2010-8
