BioSmart DC Infrared Blanket
Customer/Warranty Service: 800-596-9605
- 12 -
Matching the remote
Your remote control comes pre-programed to match the control box.
This matching protocol does not need to be performed. However, in the
event that you lose one of your controls (and we send you a new one) or a
malfunction occurs in the signal between the remote and the control box,
it will be necessary to restore (re-match) the original settings. This can be
done very easily by following the protocol outlined below.
Single remote control:
1. Turn off all other appliances and electric blankets that could interfere
with the matching transmission from the remote control.
2. Connect the power supply to the blanket and plug the power supply
into the wall outlet.
3. Press the Temperature “up” button and the power
button at the same time and hold for 20 seconds.
The power supply box will make a beeping sound
(7 beeps).
4. Once the beeping has stopped, release the two
buttons. The remote control should now be
matched to the power supply .
To match dual controls:
5. Match the first remote. To match the 1st remote,
follow steps 1-3 for single remotes.
6. The controller will beep only once and “ID” will
appear on the 1st remote display.
7. Next, follow the same steps 1-3 for the 2nd remote.
8. ID will appear on the 2nd remote display and the power supply will
beep 7 times.
9. Matching sequence is now completed. Both remotes should respond
with the power supply by beeping each time a change in the settings
is made.
L
R