Biosan LMC-3000, Инструкция пользователя

Страница: 4 / 16

4
DURING OPERATION

Do not centrifuge flammable or chemically active substances. If such liquids are
spilled on the rotor or rotor chamber, the centrifuge must be cleaned with a moist
cloth and a mild soap solution.

Do not use rotors with visible signs of corrosion, wear or mechanical damage.

Do not use the rotor without fixation nut (see figure below). Fixation procedure is
described in
4.4 .

Do not fill in the tubes after they have been inserted in the rotor.

Do not use glass tubes or tubes unsuitable for centrifugation.

Select the correct type of rotor. Some rotors have limited maximum speed (see figure
below). Selection procedure is described in
5.4.3 .

Do not leave the operating unit unattended.

Do not operate the unit in environments with aggressive or explosive chemical mix-
tures. Please contact manufacturer for possible operation of the unit in specific at-
mospheres.

Do not operate the unit if it is faulty or has been installed incorrectly.

Do not use outside laboratory rooms.

Do not place a load exceeding the maximum load value mentioned in the Specifica-
tions section of this manual.
BIOLOGICAL SAFETY

According to EN 61010-2-20, a centrifuge without a lid gasket is not considered a
biologically safe system and therefore cannot be used for centrifuging hazardous ma-
terials contaminated with toxic, radioactive or pathogenic microorganisms.

The user is responsible to carry out appropriate decontamination if hazardous mate-
rial spills on or penetrates into the equipment.
Rotor label