14
Figure 11. Polishing and deionization modules.
5.6.1.2 Remove both black corks from the module top.
Note.
Use the tool for tube detaching (figure 5, right) included in the stand-
ard set, for easier operation.
Press down the small rubber ring on the fitting with fingers (fig. 12/a) or with the tool
(fig. 12/b) and remove the cork.
a
b
Figure 12. Removing the cork.
5.6.1.3 Prepare two straight angle module connecting fittings (fig. 13/a) and insert them in
the module fittings to the stop, so that the free ends are rotated towards the side of
the module with guide rail (fig. 13/b). Check the connecting fittings for a tight fit.
a
b
Figure 13. Installing the connectors.
