BION tantulus xhp indoor, Руководство пользователя

Страница: 8 / 22

2. Wiring dimmable power supply ED series
+36 VDC power supply connect to wire 1 (marked blue), wire 2, wire 4
and wire 5 of the leader cable
GND power supply connect to wire 3 and wire 6 of the leader cable
Before commencing any installation or maintenance work, please
disconnect the power supply from the utility.
Risk of electrical shock and energy hazard. All failure should be
examined by a qualified technician. Please do
not remove the case of the power supply by yourself!
Ensure that it cannot be re-connected inadvertently!
Keep proper ventilation around the unit and do not stack any object
on it.
Also a 10-15 cm clearance must be kept when the adjacent device
is a heat source.
Mounting orientations other than standard orientation or operate
under high ambient temperature may increase the internal
component temperature and will result in a derating of output
current.
Dont suspend to direct sunlight or rain
Current rating of an approved primary /secondary cable should be
greater than or equal to that of the unit. Please refer to its
specification.
For LED power supplies with waterproof connectors, verify that the
linkage between the unit and the lightingfixture is tight so that water
cannot intrude into the system.
3. Dimming via Resistor
8 | www.biontechnologies.com