BIO UV BIOSUN 340, Руководство по установке и обслуживанию, Страница: 11 / 43

BIOSUN-340_(Anglais) - DOC012466 - Ind. B03 - 21/06/2017 Copyright BIO-UV
Marque, Modèles et Brevets déposés - Produits exclusifs Page 11
b-2.2. Installing the two P2 type formed sections
In the next steps, install the P2 and P5 type formed sections. Figure 03 provides an overview of the structure showing the
use of the formed sections (red circles).
First assemble the three formed sections together on the floor. Then attach them to the foundations, otherwise the
screws cannot be tighten!
b-2.3. Fitting the eye nuts to the P2 type formed sections
For this step, you will need four eye nuts (see figure 04, red circles), four L 8 mm dia plain washers, eight HU M8 nuts and
two P2 type formed sections.
Option: If you have the version with the GCB support (support for junction box), you also need to fit the support in
this step! (see next paragraph)
The following figure shows you what the structure should look like after this step.
•
If you do not fit the GCB support - assemble the eye nuts (see figure 04).
Side view
Rear view
Rear view Cross-section view
Large
washer
Eye nut
Base plan for P2
type formed
P2 type
Profile
Support for GCB (optional)