BINZEL-ABICOR BRS-FP, Руководство по эксплуатации

Страница: 37 / 100

BRS-FP/BRS-FPi 6 Commissioning
BAL.0028 • 2017-03-10 EN - 13
6.2 Establishing the electrical connection

Fig. 4 on page EN-12
1 Loosen the lateral mounting screws to remove the covering hood (7) . You can then access the PCB (1) .
2 Guide the connecting cable through the PG 9 screws to the PCB.
3 Apply an operating voltage of 24 V DC to X1.1 and X1.2.
4 Apply the control signal input for "START" to X1.3 or X1.4, depending on the electrical
design of the robot output.
5 Apply the control signal output for "READY" to X1.5 or X1.6, depending on the electrical
design of the robot output.
Fig. 5 Connecting the pneumatic BRS-FP/BRS-FPi system
release/clamp
Clamping cylinder
backwards/forwards
Stroke cylinder
Pneumatic motor
6 bar
Y2
Y1 Y3
Option: Injector
14
12
1 3
2 4
5
12
14
14
12
1 3
2 4
5
12
14
14
12
1 3
2 4
5
12
14
Inner width 4
Inner w
6x1
6x1
DN 4 DN 4 DN 4
DN 4 DN 6
M
Z2 Z1
S2
S1
M
Draw in from
bottle
(integrated in BRS-FPi
version)
NOTICE
The torch cleaning station must be and remain without compressed air and power during setup!
• The gas nozzle diameter must match that of the set of clamping jaws.
• The distance sleeve must match the nominal diameter of the gas nozzle.
• The reamer must be precisely aligned with the torch type.