BINZEL-ABICOR BRS-FP, Руководство по эксплуатации

Страница: 36 / 100

EN - 12 BAL.0028 • 2017-03-10
6 Commissioning BRS-FP/BRS-FPi
6.1 Connecting the pneumatic system
The BRS-FP/BRS-FPi uses cleaned and lubricated compressed air, which is supplied to the integrated
distributor block by means of a maintenance unit.
The supply line required for this purpose has a minimum inner width of 8 mm and is not included in the scope
of delivery.
NOTICE
• Please take note of the following instructions:

2 Safety on page EN-5
• The system must only be installed and put into operation by qualified personnel
(in Germany, see TRBS 1203).
• Make sure that the cleaning process is not impaired by the collecting tray and the bottle holder.
1 PCB
2 Compressed air line for motor
3 Silencer
4 Pneumatic connection
5 Electrical connection
6 Support (optional)
7 Covering hood
Fig. 4 Commissioning
200
60
6
5
4
3
2
1
7
WARNING
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• The torch cleaning station must remain without pressure until installation is complete.
NOTICE
• The cleaning capacity of the torch cleaning station depends on operating pressure, number of
revolutions of the motor and atomization of the anti-spatter fluid. Determine the most favorable
adjustment in a test run.