Binks EMG Series, Руководство по обслуживанию

Страница: 6 / 20

EN
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
NOTE
Test spray. If the finish is too dry, reduce airflow by reducing air inlet pressure.
If finish is too wet, reduce fluid flow by turning fluid adjusting knob (20) clockwise. If
atomisation is too coarse, increase air inlet pressure. If too fine, reduce inlet pressure.
The pattern size can be reduced by turning spreader valve knob (21) clockwise.
Hold gun perpendicular to surface being sprayed. Arcing or tilting may result in uneven coating.
The recommended spray distance is 150-200mm.
START-UP SEQUENCE
Connect the gun to a clean, moisture and oil free air supply using a conductive hose of at least
8mm I.D. 1.
SUCTION CUP MODELS ONLY
Attach the cup lid assembly to the fluid inlet connector (6).
GRAVITY MODELS ONLY.
Attach the gravity cup to the fluid inlet connector (6).
PRESSURE FED MODELS ONLY.
Connect the fluid supply hose to fluid inlet connector (6).
Before using the spray gun, flush it with solvent to ensure that the fluid passages are clean.
OPERATION
(SUCTION/GRAVITY MODELS)
Mix coating material to Manufacturer's instructions and strain material.
Fill the cup to no more than 20mm from the top.
DO NOT OVERFILL.
ALL MODELS
Turn fluid adjusting knob (20) clockwise to prevent fluid needle movement.
Turn spreader valve adjusting knob (21) counter clockwise to fully open.
Adjust inlet air pressure if required.
Turn fluid adjusting knob counter clockwise until first thread shows.
Spray edges first. Overlap each stroke a minimum of 75%. Move gun at a constant speed.
Always turn off air supply and relieve pressure when gun is not in use.
SB-E-2-852 R2.0 6/20 www.carlisleft.com