EN
77-2875-R7.2 (6/2015)
6 / 8
NOTE
To reduce overspray and obtain maximum efficiency always spray with the lowest possible atomizing air pressure.
CAUTION
Never use metal instruments to clean the air or fluid nozzles.
These parts are carefully machined and any damage to them will cause faulty spray.
!
AIR NOZZLE, FLUID NOZZLE, FLUID NEEDLE
1. All nozzles and needles are precision made. They
should be handled with care.
2. Do not make any alterations in the gun. To do so
could cause finishing difficulties.
3. To clean nozzles, soak them in solvent to dissolve
any dried material, then blow them clean with air.
4. Do not probe any of the holes in the nozzles with
metal instruments. If probing is necessary, use only a
tool that is softer than brass.
