Binks 3465-10CN-11S0, Руководство по обслуживанию

Страница: 3 / 20

77-3049-R3 (4/2018) 3 / 20
EN
www.carlisleft.com
DE-ENERGIZE, DEPRESSURIZE,
DISCONNECT AND LOCK OUT ALL POWER
SOURCES DURING MAINTENANCE
Failure to De-energize, disconnect and lock out
all power supplies before performing equipment
maintenance could cause serious injury
or death.
OPERATOR TRAINING
All personnel must be trained before operating
finishing equipment.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equip ment to
rupture, malfunction, or start unexpectedly and
result in serious injury.
KEEP EQUIPMENT GUARDS IN PLACE
Do not operate the equipment if the safety
devices have been removed.
PROJECTILE HAZARD
You may be injured by venting liquids or gases
that are released under pressure, or flying
debris.
PINCH POINT HAZARD
Moving parts can crush and cut. Pinch points
are basically any areas where there are moving
parts.
INSPECT THE EQUIPMENT DAILY
Inspect the equipment for worn or broken parts
on a daily basis. Do not operate the equipment
if you are uncertain about its condition.
In this part sheet, the words WARNING , CAUTION and NOTE are used to
emphasize important safety information as follows:
Hazards or unsafe
practices which could
result in minor personal
injury, product or property
damage.
!
CAUTION
Hazards or unsafe
practices which could
result in severe personal
injury, death or substantial
property damage.
!
WARNING
Important installation,
operation or maintenance
information.
NOTE
Read the following warnings before using this equipment.
READ THE MANUAL
Before operating finishing equipment, read and
understand all safety, operation and
maintenance information provided in the
operation manual.
WEAR SAFETY GLASSES
Failure to wear safety glasses with side shields
could result in serious eye injury or blindness.
NEVER MODIFY THE EQUIPMENT
Do not modify the equipment unless the
manufacturer provides written approval.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE
THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT.
FOR FURTHER SAFETY INFORMATION REGARDING BINKS
AND DEVILBISS EQUIPMENT, SEE THE GENERAL EQUIPMENT
SAFETY BOOKLET (77-5300).
KNOW WHERE AND HOW TO SHUT OFF
THE EQUIPMENT IN CASE OF AN
EMERGENCY
PRESSURE RELIEF PROCEDURE
Always follow the pressure relief procedure in
the equipment instruction manual.
NOISE HAZARD
You may be injured by loud noise. Hearing
protection may be required when using this
equipment.
STATIC CHARGE
Fluid may develop a static charge that must be
dissipated through proper grounding of the
equipment, objects to be sprayed and all other
electrically conductive objects in the dispensing
area. Improper grounding or sparks can cause a
hazardous condition and result in fire, explosion or
electric shock and other serious injury.
PROP 65 WARNING
WARNING: This product contains chemicals
known to the State of California to cause
cancer and birth defects or other reproductive
harm.
FIRE AND EXPLOSION HAZARD
Never use 1,1,1-trichloroethane, methylene
chloride, other halogenated hydrocarbon solvents
or fluids containing such solvents in equipment
with aluminum wetted parts. Such use could result
in a serious chemical reaction, with the possibility
of explosion. Consult your fluid suppliers to ensure
that the fluids being used are compatible with
aluminum parts.