Binder CB 170, Руководство по эксплуатации

Страница: 148 / 175

CB (E7) 06/2018 Page 148/174
23.2 Decommissioning
•
Turn off the chamber at the main power switch and disconnect it from the power supply (pull the power
plug).
When switching off the main power switch, the stored parameters remain saved.
•
Turn off the CO
2
supply and the O
2
/ N
2
supplies (chamber with O
2
control). Remove the gas
connections.
•
Chamber with active humidification : Empty the freshwater bag.
•
Let the inner chamber sufficiently cool down after a hot-air sterilization before removing any parts.
•
The Permadry™ water pan must not remain filled while the chamber is out of operation. Otherwise
condensation on the inner surfaces may occur. In this case, clean and dry the chamber with doors
open for at least one hour before restarting the chamber. BINDER recommends performing a hot air
sterilization of the chamber before commissioning.
•
Temporal decommissioning: See indications for appropriate storage, chap. 3.3.
•
Final decommissioning: Dispose of the chamber as described in chap. 23.3 to 23.5.
•
When restarting the chamber, please pay attention to the corresponding safety information.
23.3 Disposal of the chamber in the Federal Republic of Germany
According to Annex I of Directive 2012/19/EU of the European Parliament and of the Council on waste
electrical and electronic equipment (WEEE), BINDER devices are classified as “monitoring and control
instruments” (category 9) only intended for professional use“. They must not be disposed of at public
collecting points.
The chambers bear the symbol for the marking of electrical and electronic equipment
manufactured / placed on the market in the EU after 13 August 2005 and be disposed of in
separate collection according to Directive 2012/19/EU on waste electrical and electronic
equipment (WEEE) and German national law for electrical and electronic equipment
(Elektro- und Elektronikgerätegesetz, ElektroG). WEEE marking: crossed-out wheeled bin
with solid bar under. A significant part of the materials must be recycled in order to protect
the environment.
At the end of the device’s service life, have the chamber disposed of according to the German national
law for electrical and electronic equipment (Elektro- und Elektronikgerätegesetz, ElektroG from 20
October 2015, BGBl. I p. 1739) or contact BINDER service who will organize taking back and disposal of
the chamber according to the German national law for electrical and electronic equipment (Elektro- und
Elektronikgerätegesetz, ElektroG from 20 October 2015, BGBl. I p. 1739).
CAUTION
Violation against existing law.
∅
Do NOT dispose of BINDER devices at public collecting points.

Have the device disposed of professionally at a recycling company which is certified
according to the German national law for electrical and electronic equipment (Elektro-
und Elektronikgerätegesetz, ElektroG from 20 October 2015, BGBl. I p. 1739).
or

Instruct BINDER Service to dispose of the device. The general terms of payment and
delivery of BINDER GmbH apply, which were valid at the time of purchasing the
chamber.
Certified companies disassemble waste (used) BINDER equipment in primary substances for recycling
according to Directive 2012/19/EU. The devices must be free from toxic, infectious or radioactive
substances in order to eliminate any health hazards to the employees of the recycling companies.