“I keep trying to
make a call, but
I hear Busy tone
and the IN USE
light on the
base unit does
not come on.”
Check your handset’s display — if the antenna symbol is
flashing, make sure the mains power lead is plugged
into the back of the base unit, and the adapter is
plugged into the mains socket with the power switched
on.
If the antenna symbol is still flashing. try re-registering
the handset, as described on page 33.
If you have more than one handset registered to your
base unit, check that another handset isn’t already in
use on a call.
Multi-handset use
“I can’t transfer
a call.”
Make sure the other handset is within range of the base
unit, and is not busy on a call.
Make sure you are keying in the correct number (1 to
5) for the other handset.
Batteries
“The handset‘s
batteries are
running low
within an
hour or two.”
Before you first use the handset, you should have left it
on the base unit or charger pod for
up to 15 hours
to
charge the batteries fully. Repeat this.
You may need to
replace the batteries
. Contact the
Binatone Help Line
for advice.
“The CHARGE
light on the
base unit does
not come on.“
Clean the battery charging contacts
with a dry cloth.
Check the connections
between the base unit and the
mains power socket.
Troubleshooting
38
“I try to
recharge the
batteries, but I
still get a
warning that
they are low.”
You need to
replace the batteries
. Please note these
safety warnings:
■
Use only
NiMH (Nickel Metal Hydride) 1.2 V
rechargeable
batteries, as supplied with the handset.
■
Dispose of used batteries safely
— never burn
them, or put them where they could get punctured.
The answering machine
“The machine
won’t record
messages.”
Check the
FULL
light. If it is flashing, you need to
delete
enough recorded messages to free at least one
minute’s recording time. Or you can delete all recorded
messages to make room for new ones (see page 24).
Make sure the machine is
switched on
— the
ANSWER/MESSAGE
light should be on.
Make sure you have not selected OGM2 — with OGM2
selected, callers cannot leave messages (see page 20).
“Remote
operation
doesn’t work.”
Make sure you are using the
correct remote security
code
.
Check that you are using a
suitable tone-dialling
phone
. Some cordless or mobile phones do not
generate continuous tones and so are not ideal for
remote operation.
Don’t leave more than 10 seconds between key presses;
otherwise, your call will be cut off.
Using your S2300 on a PBX
“Last Number
Redial and/or
memory dialling
don’t work.”
When you first make a call, try pressing the
LNR/P
button for a
pause
between the outside line access digit
(e.g. 9) and the telephone number. You should later be
able to redial the number.
Troubleshooting
E:\Binatone2003\S_2300\s2300_UK_draft02.vp
27 November 2003 19:50:07
Color profile: Generic CMYK printer profile
Composite Default screen
Binatone Help Line:
01325 304 473
39
