B-500-MTRX-230-4x4 Installation Manual
Pg. 6
© 2013 Binary
™
6.2. Rear Panel
1. HDMI Inputs 1 through 4
Connect HDMI cables from sources to the matrix switch for distribution.
2. RS-232 control port (DB9)
Attach connection from control system or Windows PC for serial control of the B-500-MTRX-230-4X4.
3. IR Output to Source 1 through 4
3.5mm mono mini connections used to connect IR flashers for controlling sources. These ports may be configured to
route commands only from the IR output corresponding to the HDBaseT output number (IR zone routing), or directly
to the source selected for viewing on an HDBaseT output (IR source routing). (See Configuration Utility)
4. RJ45 HDBaseT Outputs 1 through 4
Connect 568B terminated Cat5e/6 HDBaseT cable routed to a B-500-RX-230-IR up to 230 feet away to feed HDMI
signal to display. Output simultaneously displays the same source as the HDMI output of the same number.
5. Link LED
The green Link LEDs indicate the status of the HDBaseT connection. Off= No link; On= Link is active.
6. HDMI Outputs 1 through 4
Connect HDMI cables to route to displays. Output simultaneously displays the same source as the HDBaseT output
of the same number.
7. IR Input to Room 1 through 4
3.5mm mono-mini connection for IR pass-through. Connect the control system IR Flasher outputs to send commands
to displays or other devices in the room (only when using the B-500-RX-230-IR to extend to displays)
.
8. System All IR Out
3.5mm mono mini port, repeats all IR commands from all connected HDBaseT outputs (from IR Receiver port of
B-500-RX-230-IR).
9. System IR In
3.5mm mono mini IR input port for matrix control.
10. Latch-Locking Power Jack
24V 2.7A DC power supply port with locking screw collar for secure connection.
LINK
LINK
LINK
LINK
1
3
2
4
1
3
2
4
24V DC 2.7A
2
3
4
7
8
10
6
1
9
5
