Bimar HH03, Инструкция пользователя

Страница: 14 / 34

14
polystyrene foam, nails, etc.) must be kept out the reach of children because they are potential
sources of danger; but dispose of them in accordance with current law.
•
Before connecting the appliance, check that the voltage shown on the data plate matches that
of your electricity and that the electric plug is grounded. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with another
more suitable type by professionally qualified personnel, who will make sure that the section of
the wires of the outlet is appropriate for the absorbed power of the appliance. In general, the
use of adapters or extension cords is not recommended; if their use is indispensable, they must
conform to existing safety standards and their current capacity (amperes) must not be less that
the maximum of the appliance.
•
Position the appliance far from other sources of heat, inflammable materials (curtains, carpets,
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform
on exposure to heat. Make sure that there is 120 cm of free space in front of the appliance and
50 cm on the sides.
•
Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset). Make sure the safety system get in touch with the floor, otherwise the
appliance doesn’t work.
•
Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp
edges, is not wound around the utensil, is not twisted up on itself or in the way to prevent the
utensil from being pulled over. Check that you cannot trip over to prevent accidental falls or
harm to persons.
•
All repairs should be made by a competent qualified electrician. In any case you should return
the appliance to this service.
DESCRIPTION OF THE APPLIANCE DESCRIPTION OF THE APPLIANCE DESCRIPTION OF THE APPLIANCE DESCRIPTION OF THE APPLIANCE
Frontal part: Frontal part: Frontal part: Frontal part:
⇔
Switch for swinging
Inferior part: Inferior part: Inferior part: Inferior part:
3. Wing nut screws
4. Anti-upsetting system
5. Cable slideway
6. Cable