BILT HARD 10-INCH, Инструкция по эксплуатации

Страница: 7 / 24

7
DRILL PRESS SAFETY WARNINGS
15. After turning off the drill press, wait until the
spindle comes to a complete stop before touching
the workpiece. Always turn the drill OFF before re-
moving scrap from the table.
16. Before leaving the machine, always turn OFF and
unplug the machine, remove the drill bit, and clean
the table. Turn Off and unplug the machine before
cleaning, making adjustments or changing drill bits.
Accidental start-ups may occur if the tool is plugged
in during an accessory change or adjustment.
17. CLEANING. Never use solvents to clean plastic
parts. Solvents could dissolve or otherwise dam-
age the material. Use only a soft damp cloth to clean
plastic parts.
18. REPLACEMENTS. Should any component of
your drill press be missing/damaged or fail in any
way, shut OFF the switch and remove the plug
from power supply outlet. Replace the missing,
damaged, or failed parts using only identical re-
placement parts before resuming operation.
CALIFORNIA PROPOSITION 65 WARNING
Some dust created by power sanding, sawing, grind-
ing, drilling, and other construction activities may
contain chemicals, including lead, known to the
State of California to cause cancer, birth defects, or
other reproductive harm. Wash hands after handling.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks, cement, and other
masonry products.
• Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies depending
on how often you do this type of work. To reduce
your exposure to these chemicals, work in a well-
ventilated area with approved safety equipment such
as dust masks specially designed to filter out micro-
scopic particles.
WARNING! Do not operate the power tool until you have read and understood the following instructions and
the warning labels.