Billy Goat PL2500SPH, Руководство пользователя

Страница: 6 / 14

PL25SPH Owner’s Manual
Part No 100383 Form No F020816B
6
PACKING CHECKLIST
Your Billy Goat is shipped from the factory in one carton with the handle and cables detached.
PUT OIL IN ENGINE BEFORE STARTING
ASSEMBLY
READ all safety instructions before assembling unit.
TAKE CAUTION when removing the unit from the box.
69
NOTE : Items in ( ) can be referenced in the Parts Illustration and Parts List on pages 10-11.
1 . REMOVE the two bolts and nuts from the hardware bag (item 44 and 5).
2. ATTACH the upper handle (item 70) by sliding it into the rear facing holes and attaching it with the hardware from step 1.
NOTE : The bail should be facing downward.
3. ATTACH the tine lift cable (item 49) to the tine lever (item 69) in the center of the handle by inserting the pin (item 88) into
it in the hole closest to the end of the handle and then inserting the rue ring (item 6). See Fig. 1 below and reference Part
Illustration on page 10.
4. ATTACH the drive cable (item 78) to the left side bracket on the handle (item 70) by sandwiching the two nuts on the
bracket and tightening. Install cable adjuster (item 71) by threading it on the end of the cable until thread begins to show.
NOTE : Protruding portion of the threaded adjuster must be facing the operator when installed . Check to make sure
the cables are functioning properly before operation and not binding. If adjustments are needed for belt tension on the bail
cable, loosen the nuts and move the sandwiching position up or down for the desired tension.
NOTE : if the tension is too loose the tines will not engage and if it is too tight premature wear could happen to the belt.
5 . ATTACH the tine cable (item 77) to the right side bracket on the handle (item 70) using the same method previously used
for the drive cable. Check for proper operation and adjust the tension accordingly.
6 . CHECK engine oil level and fill to proper level. Also check oil in gear reduction reservoir and fill if necessary. See engine
owner’s manual for type and amount of oil to use. Move the tine engagement lever to the down position, to level engine
during checking.
7 . SET the engine stop switch, located on the upper handle, to the ON position.
Boxing Parts
Checklist
Owner’s Manual
100383
Engine Manual Per
Model
Honda
PARTS BAG & LITERATURE ASSY
Warranty card P/N-
400972, Owner’s Manual P/N-100383, Declaration of Conformity P/N-381503, General
Safety and Warranty Manual Renovation P/N-100295
Attach (item 49) cable here
Fig. 1
handle