Part No. 100384
5
Operation
Item numbers in parentheses can be referenced in the Parts Illustration and Parts List on pages 7-9.
Operating Instructions
The AET60 is a combination of a tow-behind aerator and a 3-point aerator with two wings for
adjustable aeration widths. When used behind a tractor in the 3-point application, there are pins on
each tine assembly that can be removed to allow tines to swivel, enabling the tractor to turn while still
aerating with the tines in the ground. When being towed, the tine assemblies must be locked in place
for proper tracking.
Aerating Operation
NEVER PARK THIS UNIT ON A SLOPE OF ANY KIND. Always keep tines in the up position when
parking the unit.
Using as a Tow-Behind
When using this machine as a towable aerator, the tow link should be in the down position and
attached to the frame of the aerator using the two clevis pins (item 19). The tow behind is telescoping
so that it can be extended to accommodate various vehicles. Make sure all five lock pins (item 21) are
in place on the axle assembly to prevent the assembly from swiveling. When operating, the wings can
either be up or down depending on the width of aeration desired. In normal conditions, there will be
adequate weight for proper penetration when the wings are up; when the wings are down, additional
weight may be required.
Using in a 3-Point Application
When used with a tractor and a 3-point hook up, the inner and outer tow link should slide together and
be in the upright position holding it to the frame with the two clevis pins (item 19). The two table on the
outer tow link are for the center link on the 3-point. Remove the five lock pins (item 21) from the tine
axle to allow the assembly to swivel.
Raising and Lowering Tines
The tines are raised or lowered into the ground by operating the crank on the cylinder to raise or lower
the tines to the desired depth. Tine penetration is very dependent on surface preparation. READ the
entire operation section before aerating.
•
Set Tine Depth
: With the aerator in the work area, lower the tines into the ground by rotating the
crank at the rear.
•
Transport
: Be sure to raise tines out of the ground before transporting away from the work area.
Caster Raising/Lowering
The caster can be raised or lowered by removing the pin and rotating the caster then reinserting the
pin to lock it into position. DO NOT transport with the caster in the down position so that it comes into
contact with the ground. DO NOT unhitch the unit on uneven terrain with the caster down as the unit
may roll. To prevent unwanted roll, chock the wheels.
NOT FOR REPRODUCTION
100384_A_
LO
