13
12
14
When fitting more than one unit in a run,
then connect the two frames through
redundant fixing holes
Prior to drilling, so as not to cut or
puncture fuel tanks, fuel lines, brake
lines, electric wires, etc. Check behind
or underneath drilling mounting
locations. All floor mounting bolts near
the fuel tank area should be installed
from the underside of the vehicle, to
guard against the fuel tank being
punctured in the event of a collision.
This would mean NOT using Blind
Fasteners in this area!
If fixing to the floor is also required mark
fixing locations through the base of the
frames onto the floor off the vehicle
Remove the Racking unit(s) & carefully
measure the bracket positions
Refit & secure the Racking unit(s)
10
11
Assembly - Fitting Van Racking into Vehicle
8
VR: 12/11
Caution
Wear appropriate
clothing, protective
gloves and footwear
are recommended
If in doubt please
contact your
supplier
Please read
these instructions
Inspect all packages
for damage and check
that all the components ordered
are included
Assembly should be undertaken
by at least 2 competent persons
Tools required
We recommend
this product is
fixed to the floor
Caution!
During assembly
Take care when
handling heavy objects
Build on a suitable
level floor surface
Allow adequate
working space
and be aware of others
working around you
Dispose of packaging
materials responsibly
Warning
Never climb on the structure
Do no lean ladders,
steps or other
objects against the shelving
Always use safety
steps to reach high
shelves
Load heavy items
on the lower shelves
This product is designed for
hand loading only
Do not use in damp
or wet environments
Ensure that maximum
load carrying capacities
are not exceeded
Please refer
to the loading
chart supplied
for details
From the underside of the vehicle drill
the anchor holes making sure they are
clear of any Fuel lines, Electrical Wires
or that there is an adequate distance
from the fuel tank
