Big Lift D40, Эксплуатация, обслуживание, запасные части

Страница: 28 / 132

4-10 BL-D40-0515 - 01-27-2019
Figure 4-4 Throttle Regulation
Parameter Factory Setting Description
THROTTLE X POINT 45% This parameter together with the THROTTLE Y POINT, changes
the characteristic of the accelerator input curve: when the acceler-
ator is de-pressed to X point percent, the corresponding truck
speed is Y point percent of the Maximum truck speed. The rela-
tionship between the accelerator position and the truck speed is
linear between the THROTTLE 0 ZONE and the X point and also
between the X point and the maximum accelerator position but
with two different slopes (
Figure 4-4 ).
THROTTLE Y POINT 68% This parameter together with the THROTTLE X POINT, changes
the characteristic of the accelerator input curve: when the acceler-
ator is de-pressed to X point percent, the corresponding truck
speed is Y point percent of the Maximum truck speed. The rela-
tionship between the accelerator position and the truck speed is
linear between the THROTTLE 0 ZONE and the X point and also
between the X point and the maximum accelerator position but
with two different slopes (
Figure 4-4 ).
ADJUSTMENT #01 LEVEL = 5 Adjust the upper level of the battery charge table (Level 0 to 9).
ADJUSTMENT #02 LEVEL = 5 Adjust the lower level of the battery charge table (Level 0 to 9).
LOAD HM FROM
MDI
OFF When set On, the Hourmeter of the Controller is transferred and
recorded on the Hourmeter of the Standard MDI (connected on
the Serial Link).
CHECK UP DONE OFF Turn it On when asked Maintenance service has been executed to
cancel the CHECK UP NEEDED warning.
CHECK UP TYPE NONE It specifies the handling of the CHECK UP NEEDED warning:
• NONE: No CHECK UP NEEDED warning.
• OPTION#1: CHECK UP NEEDED warning on the handset and
MDIPRC after 300 hours.
• OPTION#2: Equal to OPTION#1 but Speed reduction after 340
hours.
• OPTION#3: Equal to OPTION#2 but the truck definitively stops
after 380 hours.
R6642