5 |
P a g e
INSTALL CANOPY COVER
Loosen 2 screws from the bottom of the mounting bracket.
Slide the canopy up to the mounting bracket and place the key hole on the canopy over the screw on the
mounting bracket, turn canopy until it locks in place at the narrow section of the key holes, secure it by
tightening the two set screws. Avoid damaging the electrical wiring prepared previously.
Finally attach the canopy cover to canopy and secure it by pushing the lugs into the holes.
Fig. 7
BLADE INSTALLATION
Attach the blade holder to the motor by lining up the position label (1, Fig. 8) and secure it by tightening 6 screws
(Fig 9.)
Insert the blade screws through the blade assembly in the following order
—
blade holder, blade and blade
bracket kit. Then secure the blade to the blade holder by tightening the 3 screws (Fig. 10).
Push the blade decorative kit into the end of the blade and secure it by tightening the screw.
Repeat to install the other blades to the blade holder.
Finally install the bottom cover to the shaft of the motor by rotating it clockwise (Fig.11).
Fig. 8 Fig. 9
