RESPIFIT S
16
The strength training is concluded either once the required number of
individual exercises has been completed or the number of permitted
failed attempts has been exceeded.
A separate screen indicates whether the training (exercise block) has
been successfully completed or not.
Figure 15: Training successful
Figure 16: Training failed
Unplug the power supply unit to shut down the device.
If both strength training and endurance training have been set up by the
treating physician / therapist, press the
button to access the
endurance training.
4.2 The endurance exercise
Important:
A nose clip must be used for carrying out the exercises set
out below. Breathe freely without the handheld patient module between
individual exercises to ensure sufficient tidal breathing.
For the endurance exercise, inhalation is carried out against a pre-
established resistance. The cross-section of the air duct is reduced by
the set aperture (A, B or C).
Inhaling and exhaling through the handheld patient module at normal
breathing rate (tidal breathing frequency) moves the balloon up and
down on the screen. The balloon moves up with each inhalation and
drops back during exhalation. The exercise is deemed to have been
successfully completed if the balloon does not touch either the floor or
the sky during the one-minute exercise duration. The exercise starts as
soon as the first breath is taken.
One endurance training session (exercise block) consists of up to 20
individual exercises. A defined number of failed attempts may be
permitted per exercise block.
There must be a pause between the individual exercises, for recovery. A
minimum pause time of between 1 and 20 seconds is stipulated. The
device is subsequently ready for the next individual exercise.
Содержание RESPIFIT S
Страница 31: ...RESPIFIT S 31 NOTES ...
