Industrial Air Curtain
1
Introduction
Version 2.1, English (27-10-2008)
7
n
Note
:
On delivery, some parts may have been
packaged within the unit (behind the inspec-
tion panel).
1.4.2
Accessories
With each installation:
-
control unit (always required)
With vertical installation:
-
base plate (recommended)
1.4.3
Parts not supplied
The following parts required for installation
should be purchased from other suppliers:
-
threaded rods (metric M12)
-
cable to connect unit and control unit
-
isolating switch
-
fuse for control unit
-
door contact switch (optional)
-
room thermostat (optional)
1.5
Safety instructions
1.5.1
Operation
w
Warning:
Do not insert any objects into the intake
and discharge openings.
Never block the intake and discharge
openings.
ç
For units with heating: the intake side can
be hot.
1.5.2
Installation, maintenance and
service
w
Warning:
The unit may be opened by qualified
technical staff only.
ê ç
Before opening the unit:
-
Switch the unit off with the control unit.
-
Wait until the fans have stopped.
-
Allow the unit to cool down as the heat
exchanger can be very hot.
-
Switch the unit off at the mains.
-
Close CH supply (if possible).
w
Warning:
The fins of the heat exchanger are sharp.
