Bicker Elektronik UPSI-1208, Руководство пользователя

Страница: 41 / 74

41
English
UPSI-1208(D) | UPSI-2406(D)
3 Intended use
This device is built for being mounted into a case (not valid for UPSI-1208D / UPSI-2406D).
Suitable enclosures must be used to protect against mechanical, electrical and fire
hazards. The device is intended for professional use in applications such as industrial con-
trol, office, communication and measurement technology. It must not be used in devices
or equipment where a malfunction will cause serious injury or endanger human life.
The functional purpose of the UPS is bypassing short-term and long-lasting power
failures and/or fluctuations. However, it may also be used for user-scheduled power-downs
of mains and cycles, e.g. replacing larger batteries in vehicles, while continuing to power
the electronics, opening or closing safety valves after a malfunction or shutting down
a system. Supercapacitors (also called ultracapacitors or EDLC) and Li-Ion battery packs
with LiFePO4 technology are used as storage medium.
An important characteristic of the UPS is the fact, that the output voltage is constantly
regulated during backup operation without dropping when the accu voltage decreases.
For an increase of lifetime the batterypacks will be charged quick by optimized charging
algorithms.
4 Assembly and installation advice
Installation and operation of this device is only allowed to be executed from
qualified personnel.
The UPS is an assembly part which is preferably used inside a
metal casing (not valid for UPSI-1208D / UPSI-2406D).The end device must comply to EMC
standards. Mounting must be done by expert staff only. During the installation process
compliance of all electrical safety standards has to be ensured. The application as well
as the electronic board must be separated from any power during the mounting pro-
cess. Wires have to be connected safely and must not have contact with sharp edges.
Pay attention to correct polarity!
Warning: Risk of burning!
The device must not be touched during operation or immediately after
switch-off. Hot surfaces can cause burnings!