Page 5 of 19 M7998 Issue 2.3
3. SAFETY INFORMATION.
This product has been designed for safe operation when used as detailed in accordance with the
Manufacturer’s instructions.
NOTE:
Failure to use this equipment in accordance with the manufactures operating instructions may
compromise your basic safety protection afforded by the equipment and may invalidate your
warranty / guarantee. The warranty / guarantee will not cover damaged caused by faulty installation
or misuse of the equipment.
3.1.
Prevention Fire and Electric Shock.
To prevent a risk of fire or electric shock,
DO NOT
open the
Imntegrity10 or PSU or IR control unit without authorisation.
Only qualified Service Personnel should attempt to repair this
product.
Only use the Power Supply Unit supplied with the IR Control
Box. (15v 4.2A output).
Never
Operate this equipment with out connection to earth /
ground. Ensure the mains supply voltage is correctly earthed
/ grounded in accordance with current area legislation.
3.2.
General Safe Operating Practice.
Always follow good laboratory practice when using this
equipment. Give due recognition to your company’s safety and
legislative health & safety procedures and all associated legislation
applicable to your areas of operation. Check laboratory procedures
for substances being heated and ensure all hazards (e.g. explosion,
implosion or the release of toxic or flammable gases) that might
arise have been suitably addressed before proceeding. When
heating certain substances the liberation of hazardous gases may
require the use of a fume cupboard or other means of extraction.
Ensure equipment is used on a clean, dry, non-combustible, solid
work surface with at least 300mm suitable clearance all around
from other equipment.
Ensure the Reaction Station PSU is positioned on a clean, dry, non-
combustible surface with a sufficient space for the power cable to
Integrity10 and mains input lead and plug set to enter / exit without
undue bend stresses. Ensure a suitable clearance for air flow and
heat dissipation.
Always keep the IR Control box well out of the way from chemical
splashes.
Ensure the coolant fluid is connected and running through the
Reaction Station prior to connecting mains power to the unit.
Always connect the Clarity system as detailed Section 5,
‘Installation’. Observe the system connection.
Do not
position any item of your equipment so that it is difficult to
connect / disconnect from the power cable assembly.
Do not
position any item of your equipment so that it is difficult to
connect / disconnect from the coolant fluid supply.
Do not
position any item of your equipment so that it is difficult to
connect / disconnect data and communication cables.
Do not
position the Reaction Station PSU so that the on / off switch
is inaccessible.
Содержание Electrothermal ATS10232E
Страница 12: ...Page 12 of 19 M7998 Issue 2 3...
