Biasi Riva Plus HE M296.24SR/C, Руководство по обслуживанию, Страница: 11 / 40

- 11 -
Primary heat exchanger
5 primary heat exchanGer
5 .1 function
The primary heat exchanger A in Figure 5.1 has the function of
transferring heat produced from combustion of the gas to the
water circulating in it.
figure 5 .1
a
The hydraulic circuit is composed of 8 elliptical pipes connected
in parallel (Figure 5.2).
figure 5 .2
5 .2 removal
warning: isolate the boiler from the mains electricity
supply before removing any covering or component .
1 Remove the case panels and the sealed chamber lid (section
"Body panels" page 5).
2 Empty the primary circuit of the boiler.
3 Remove the combustion chamber lid B by unscrewing the
screws C (Figure 5.3).
4 Remove the screws D and the plate E.
5 Remove the clip F.
6 Loosen the connection G and slightly move the pipe H up-
wards.
7 Remove the clip I and the safety thermostat J. It is not neces-
sary to disconnect it from the wiring.
figure 5 .3
f
h
n
p
J
i
K
m
e
O
G
c
b
c
d
l
8 Loosen the connection K and move the pipe L downwards
freeing it from the connection of the primary heat exchanger.
9 Remove the clip M.
10 Loosen the connection N.
11 Free the pipe O from the connection of the condensing heat
exchanger; lift and rotate it towards right.
12 Remove the heat exchanger by sliding it forwards.
13 Reassemble the boiler carrying out the removal operations in
reverse order. Fit the clip I with the arrow pointing upwards as
illustrated in Figure 5.3.
impOrtant: do not force the connection G when
tighting it .
5 .3 cleaning
If there are deposits of soot or dirt between the blades of the
heat exchanger, clean with a brush or non-metallic bristle brush.
In any case, avoid any actions that can damage the protective
varnish with which the exchanger has been covered.
warning: after cleaning or replacement as detailed
above, if it deemed necessary to undertake a com-
bustion analysis, refer to the appropriate chapter
maintenance of the installation instructions manual .