Biamp NPX G1040, Руководство по установке и эксплуатации

Страница: 3 / 15

NPX Installation and Operation Guide page 3
4. Secure the foot to a flat surface. Cut a hole into the surface, below or
just beyond, where the RJ-45 port at the back of the NPX will be located.
Route RJ-45 up through the hole as shown in Figure 6.
5. Insert the RJ-45 into the port at the back of the NPX as shown in Figure 7.
6. Install the NPX onto the foot by pressing down and sliding to the right as
shown in Figure 8.
PRODUCT INSTALLATION
Install away from heat sources such as vents, radiators, heat registers and
stoves or near water or steam. Do not exceed the maximum ambient operating
temperature of 32-104° F (0-40° C).
The two types of devices (handheld and gooseneck) may be installed in almost
any location that is convenient for the room design requirements. This includes
setting or attaching the device on a flat surface or to a wall. A Kensington lock
can be used for added security while still allowing the NPX to be moved around.
Surface-Mount Installation
1. Determine where the NPX is to be located.
2. Remove the foot from the NPX by inserting a small Philips screwdriver
or similar tool, with a maximum 3/16” (4.7mm) diameter, into the hole as
shown in Figure 4.
3. While pressing and holding the tool in the hole, slide the foot to the left and
lift it away from the device as shown in Figure 5.
Figure 8: NPX Installation
1
2
A security slot can accommodate a
Kensington
®
lock (not included) Figure 9.
Figure 4: Foot Release
Figure 5: Foot Removal
2
1
Figure 6: Foot Installation
Figure 7: NPX Connection
Figure 9: Security Slot