background image

4

Equalization

If Assistance is Required 

Call (800) 989-6275.

If a sound level meter is available, the following spectrums are recommended:

FREQUENCY  

100   125   160   200   250   315   400   500   630   800   1000   1250

1/3 OCTAVE    

47  

46  

45  

44  

43  

42  

41  

40  

39  

37  

35  

34

ONE OCTAVE  

 

51  

 

 

48  

 

 

45  

 

 

40

FREQUENCY  

1600   2000   2500   3150   4000   5000   6300   8000   1000

1/3 OCTAVE    

32  

30  

27  

24  

21  

20  

17  

14  

11

ONE OCTAVE  

35  

 

 

26  

 

 

19

C. Connecting & using microphone paging

1. 

Connect a 40 Watt or (less load) to the 70 Volt output or an 8 ohm load to the 8 ohm output. Only one 
can be used at a time. Don’t attempt to use the 70 Volts and 8 Ohm outputs simultaneously.

2. 

Turn all front panel controls to “0”. Note that the bass & treble controls are at mid range when at 0.

3. 

Plug a good quality low impedance microphone with an on-off switch into the XLR microphone 

connector on the rear panel and switch the microphone to on.

4. 

Connect the DS1092 to a nominal 120 Volt 50-60 Hz source.

5.  The green power LED should be lit at this time.
6.  Set the master volume control to 10 (straight up).
7.  Gradually increase the microphone level on the front panel while speaking into the microphone at a 

normal tone of voice. Slowly increase the master volume if more gain is needed.

8.  Adjust the bass & treble controls for the maximum intelligibility.

D. Connecting and using telephone paging

1. 

Connect a 40 Watt (or less) load to the 70 Volt output or an 8 ohm load to the 8 ohm output. Only one 
can be used at a time. Don’t attempt to use the 70 Volts and 8 Ohm outputs simultaneously.

2.  Turn all front panel controls to “0”. (The bass & treble controls will be at mid range)
3. 

Connect the DS1092 to a nominal 120 Volt 50-60 Hz source.

4. 

Connect the balanced, dry (no battery or ringing voltage), output from your PBX to the screw terminals 

on the DS1092 rear panel.

5.  The green power LED should be lit at this time.
6.  Dial the paging code on your phone system and slowly increase the page control on the front panel for 

the desired level while speaking into the telephone.

7.  Set the bass and treble controls for maximum intelligibility.

Отзывы: