YV 20 Vibron
BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610
www.bhnorthamerica.com • Phone 949-206-0330 • Fax 949-206-0350
21
SECTION 6
START-UP
1. Plug the power cord (35) into the socket (M) on the column,
Fig.5
. The other end of the cable is
plugged into the electric wall socket (120V). Set switch (L) to position (I),
Fig.5
.
Note:
A mechanical knocking noise is normal when the vibration motors first begin to turn, this will stop as
soon as the motors reach working speed. Similarly, when the motor is switched off you will also hear
this knocking noise as the motor slows down, but it will stop as soon as the motor is at a standstill.
2. Press the ON/OFF key, select the desired time, frequency
and amplitude. Press the START key and the platform will
start after a few seconds.
3. If you have not selected any settings (Time, Frequency and
Amplitude), the system will be set to 30 seconds, 30 Hz and
low amplitude by default. You can change the time and
frequency setting during use but
NEVER CHANGE THE
AMPLITUDE SETTING WHILE THE MOTOR FOR THE
PLATFORM IS RUMMING.
Note:
A mechanical knocking noise is normal when the vibration
motor first begins to turn, this will stop as soon as the motors
reach working speed.
Similarly, when the motor is switched off you will also hear a
knocking noise as the motor slows down, but it will stop as
soon as the motor is at a standstill.
Suggested Routines
4. You can stop the platform at any time by pressing the STOP key.
