BH Fitness T9 Treadmill
BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610
www.bhnorthamerica.com • Phone 949-206-8152 • Fax 949-206-0013
25
SECTION 5
PREVENTIVE MAINTENANCE
The running belt can shift to one side or simply ‘skid over’
when running. Operate the treadmill at 3 mph for a few
minutes to determine which side the belt is drifting
towards, left or right. To center the belt using the 8mm
Torque wrench.
If the belt is drifting left
i) Turn the treadmill off and unplug from the outlet.
ii) Tighten the left hexagonal head socket a ¼ turn
(clockwise)
iii) Loosen the right hexagonal head socket a ¼ turn
(counterclockwise)
iv) Run the belt at 3 mph again for a few minutes
If the belt continues to drift to the left, repeat steps
If the belt is drifting right
i) Turn the treadmill off and unplug from the outlet
ii) Tighten the right hexagonal head socket a ¼ turn
(clockwise)
iii) Loosen the left hexagonal head socket a ¼ turn
(counterclockwise)
iv) Run the belt at 3 mph again for a few minutes
If the belt continues to drift to the right, repeat steps
Once the running belt has been adjusted closer to the
center, the treadmill can be powered on again.
It is recommended that the deck be lubricated every
6~12 months according to the frequency of usage.
WARNING!
Do not use cleaner under the running belt.
i)
Turn the treadmill off and unplug from the outlet.
ii) Use 8mm Torque wrench to loosen the
hexagonal
head socket
in the end caps. Remove excessive
accumulations of dust, dirt, and other substances
from running deck. ONLY use a clean soft cloth.
iii) Gently pull up the side of the running belt and
dispense a thin layer of the lubricant on deck, and
spread evenly. DO NOT over lubricate
iv) Center the belt (use the instructions above), and
tighten the
hexagonal head socket
.
Check belt condition and if necessary adjust using the
instructions above.
Rear Roller
Hexagonal
Head Socket
Home use:
4 Miles or less / hr = lube every 1 year
4~8 Miles / hr = lube every 6 months
8 Miles or more / hr = lube every 3 months
Commercial use:
Lube every month
Use 8mm Torque
wrench
