BH FITNESS BT7535, Руководство пользователя

Страница: 7 / 11

FAULT FINDING CHART
PROBLEM CHECKS SOLUTIONS
1.The monitor does not 1) Make sure that the 1) Plug the machine into the
switch on. machine is plugged in, the mains supply. Set the switch to
ON/OFF switch in position 1 position 1 and insert the safety
and that the safety key is key.
inserted.
2.The monitor switches 2) Check that the current 2) Switch the machine off and
on but the motor fails limiter is pressed in. press the circuit breaker in.
to start. Lubricate the treadmill band.
3.Walking motion is 3.a) Check that the belt is 3.a) Lubricate the sliding belt.
jerky on the lubricated. 3.b) Adjust the belt tension.
treadmill. 3.b) Check the tension on the 3.c) Adjust the drive belt tension.
sliding belt.
3.c) Check the tension on the
drive belt.
4.The machine stops 4) Check that the band is 4) Reset the overload button with
(the breaker trips). lubricated.
the On /Off switch at „0“ and
lubricate the treadmill band.
5.Electrical shocks 5) Check that the machine is 5) Plug the machine into an
through the handrail. plugged into an earthed earthed mains socket.
mains socket.
6.The treadmill belt 6.a) Check that the machine
skews off centre. is level on the floor.
6.b) Check that the machine
does not wobble.
ERROR CODES
Monitor screen display
Possible cable fault.
Connect the wire well between top
E1 controller and bottom controller
Monitor screen display
Burst clash.
Operating with incorrect voltage; Connect
E2 the motor wire again.
Monitor screen display
No speed sensor signal
Replace the sensor light on the bottom
E3 controller or speed sensor.
Monitor screen display
Possible motor overload. Lubricate the belt.
E5
Monitor screen display
Safety key. Insert the safety key.
E7
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services .
6