EN
40
USER MANUAL EASYGO / EVO / NITRO / AWD
1.
Wheel Size Selection.
The user can change the size of the wheel at any time. When doing so, the panel will display the
size of the wheel's circumference in millimetres and its equivalent in inches (16, 20, 24, 26, 27’5,
28 or 29). This size can be changed using the (+) and (-) buttons.
The circumference of the wheel is measured as follows:
2.
Metric and Imperial Systems.
The user can switch between the metric system (kilometres) and imperial system (miles) by
pressing the (+) or (-) buttons, to select the units of distance and speed.
3.
SNOW motorisation (only works in models with AWD dual motors).
AWD models have 2 motors on the front and rear hubs. Pressing the (+) and (-) buttons allows
you to select one of the following motor modes:
•
ALL. The two motors work simultaneously, with traction control activated.
•
ECO. The two motors are coordinated and complement each other to achieve energy
effi ciency.
•
FRONT. Only the front motor works.
•
REAR. Only the rear motor works.
•
OFF. Select this option for e-bikes that are not AWD.
ATTENTION
For models without AWD dual motors to work correctly, you must select
motor mode OFF.
ATTENTION
The AWD models are not approved under standard EN 15914 and are
therefore only intended for off-road use.
4.
Battery Capacity.
To accurately calculate the range, it is necessary to correctly determine the capacity of the
battery being used (i.e. 10 Ah, 12 Ah, etc.).
5.
Controller Temperature (only available on the Central Display Panel)
The user can view the temperature on the controller in degrees centigrade.
6.
Torque Sensor Reading (only available on the Central Display Panel).
The user can view the reading from the torque sensor in volts. The reading on the sensor varies
according to the pressure on the pedal. The sensor is considered to be properly calibrated when the
reading gives a voltage of between 0.5 V and 1.5 V in a resting position, with no pressure on the pedal.
7.
Battery Deterioration (only available on the Central Display Panel).
The user can fi nd out the state of deterioration of the battery by viewing its actual capacity in Ah.
8.
The Controller's Firmware Version (only available on the Central Display Panel).
The user can see the version of the controller's fi rmware that is installed.
1
3
