11
• A skilled licensed electrician must be asked for any repair of the
electric system. Strictly perform electric connections in compliance
with the applicable rules of the country.
• Strictly use original parts. DANGER : the manufactuer is not respon-
sible for damages/injuries caused by the use of non original spare
parts.
• Repairs of any other part of the machine may be strictly performed
by the manufacturer.
5.1. Placement
• Install the splitter on a 60 - 75 cm high table, to obtain an
ergonomic and safe working position.
• Provide a flat, clear working surface and due, proper illumination
of the room.
• Never operate a log-splitter near diesel oil, fuel, gasoline or other
flamable materials.
• The working area around the machine must be kept as clear as
possible from surrounding obstacles and slippery foundation
floors should be duly treated.
5.2. Start-up
• Before you start working with the log-splitter:
- inspect the conditions of the connection lines and
- inspect the machine to detect eventual visible damages
- check the correct tightness of all screws
- check the hydraulic system for eventual leaks
• Check the general conditions and make sure that the splitter is duly
assembled with all its parts and fittings.
• Hand guards installation is mandatory for safety reasons. Working
without will impair other parties‘ liabilities in the event of a personal
injury.
5.3. Electric specs
• Check the compliance of your network power specs with the ones
of the identification label and plug the machine to a compliant
approved socket.
• Strictly use extension cable of the correct section.
• Provide connection to the network by ways of a 30 mA RCD
(residual current device)
• Required domestic overload safety is 8.5 A.
5. OPERATION AND SETUP
