BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 8349
HDI Injektor Puller
TOOLS
1
Pull spindle, for the electromagnet internal thread in the injector
2
Pull spindle, for the internal ring nut thread in the injector
3
Bridge with ball bearings
4
Support bolt
5
Support bolt
6
Support bolt with internal thread
7
Internal hexagon socket for dismantling the inner ring nut
8
Slotted socket wrench for dismantling the electromagnet
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool set enables HDI injectors (Bosch and Siemens) to be dismantled without dismantling the
cylinder head and is suitable for vehicles with 2.0 HDI (DW10 and DW12) PSA engines, also installed
in Toyota, Mazda and Hyundai models.
The extractor unit can be supported by a special design on the cylinder head and thus enables a high
tensile force.
SAFETY INFORMATIONS
•
Use the tool only for the work specified under intended use.
•
Observe the generally applicable safety instructions for workshops.
•
Keep your work area tidy and clean. Blocked areas or aisles increase the risk of injuries.
•
Always wear gloves and safety glasses when working with this tool kit.
•
Make sure you have a safe, non-slip stance when working.
•
Check the condition of the tool regularly and do not use it if it is damaged.
•
Make sure that the tool is properly installed.
•
Do not overtighten or use excessive force on the spindle as this can damage both the tool and
the component.
