BGK AutoCure 5000, Сборка и руководство по эксплуатации

Страница: 5 / 46

5
Operating Instructions
Temperature Controller Single or Double Ramp Operation (See Figure 1)
Single Ramp Operation: The temperature ramps in a predetermined amount of time from ambient to a set
point temperature and holds at that temperature for a required amount of time.
Double Ramp Operation: The temperature ramps in a predetermined amount of time from ambient to the first
set point temperature and holds at that temperature for a required amount of time, it then ramps in a
predetermined amount of time to a second set point temperature and holds at that temperature for a required
amount of time.
Temperature Controller Displays
The upper display indicates the mode of the heating cycle and the process temperature. During the Ramp mode
the upper display will toggle between the process temperature and ramping. Once the cure temperature (set
point) has been reached the upper display will toggle between the hold time remaining (in minutes) and the
process temperature. When the hold time becomes less than one minute the upper display will toggle between
the hold time remaining (in seconds) and the process temperature. The lower display indicates the cure
temperature (set point).
Cycle Start Button
The product will heat to the set point temperature and remain there for the time selected. The hold time will
start when the temperature reaches 15°F before set point.
Heater Position
If the heater is too far from the product, the temperature will not be reached and the hold timer will not be
activated.