BFI Automation CFC 4000L, Оригинальная инструкция по эксплуатации

Страница: 41 / 56

5
5.1
5.2
5 Description
5.1 Type plate
The type plate is located on the device housing and co
tains the device type designation and the serial number.
5.2 Functional description
For flame radiation analysis the compact flame controller
is using the integral method in the respective spectral
range.
After pre-amplification, the undesirable unmodulated light
portion is removed from the output signal of the wear
detector. The subsequent sensitivity setting permist an a
tenuation of the signal for adaption to the firing conditions.
The downstream bandpass ensures that only the typical
flame radiation modulation of the primary combustion
zone is evaluated. This allows extraneous light signals
from neighbouring burners to be distinguished from the
monitored flame.
Further function groups include i.a. the signal processing
for the dynamic monitor channel that c
tors the fault-free state of the device.
A part of component defect results in the immediate
switch-OFF of the flame relay that represents a floating
changeover contact for processing in the burner contro
ler.
The switching status is additionally indicated by a yellow
LED on the rear side of the device behind the perspex
panel.
For optimum adjustment of the compact flame controller,
the flame intensity can be read off directly at the device by
means of the pulsating green LED. A current outp
0(4) to 20 mA is available for visualisation or remote di
play.
The safety switch-OFF time that depends on the fuels to
be monitored is set at the manufacturer's works to 1 se
ond. Longer switch-OFF times can be set, if required.
Description
5-1
plate is located on the device housing and con-
he device type designation and the serial number.
For flame radiation analysis the compact flame controller
the integral method in the respective spectral
amplification, the undesirable unmodulated light
ortion is removed from the output signal of the wear-free
detector. The subsequent sensitivity setting permist an at-
tenuation of the signal for adaption to the firing conditions.
The downstream bandpass ensures that only the typical
ion of the primary combustion
zone is evaluated. This allows extraneous light signals
from neighbouring burners to be distinguished from the
Further function groups include i.a. the signal processing
that continuously moni-
free state of the device.
A part of component defect results in the immediate
of the flame relay that represents a floating
changeover contact for processing in the burner control-
onally indicated by a yellow
LED on the rear side of the device behind the perspex
For optimum adjustment of the compact flame controller,
the flame intensity can be read off directly at the device by
means of the pulsating green LED. A current output with
0(4) to 20 mA is available for visualisation or remote dis-
time that depends on the fuels to
be monitored is set at the manufacturer's works to 1 sec-
times can be set, if required.