11
When connecting hoses to your
Laundry Pro 2.0 hand start the hose
connector(s). Using adjustable pliers, finish
tightening hose connector(s).
CAUTION:
Some washing machine models require water pressure to both the Hot and Cold valves for proper
operation. In some cases, if only the COLD water side is connected, the water valve will not operate
or the washing machine will not fill to the proper level. To solve this problem, the installation of
a “Y” adapter (available at most hardware stores) may be used. The use of the “Y” adapter allows
water to flow equally through both the HOT and COLD water valves. Optional stainless steel hose
(item #: 49701-US) must be installed on the hot water connection. To Install, turn water off at the
valves and disconnect the existing HOT water hose (at the valve and washing machine). Connect
the “Y” adapter to the outlet on your Laundry Pro 2.0, then connect both the optional stainless
steel hose (item #: 49701-US) and Cold hose from your washer to the “Y” adapter (see diagram
below). Operate your washer on the WARM/WARM setting (your Laundry Pro 2.0 will still be using
just cold water).
Turn off both water valves (hot and cold)
before disconnecting hoses. Failure to
follow these instructions may result in water
leakage and/or possible injury
from hot water.
CAUTION:
NOTE:
Your hot source water valve will not have a hose connected to it.
Make sure it is fully turned off. It is recommended you secure a cap
(available at most home improvement stores) to prevent leakage.
NOTE:
The “Y” adapter needs to be purchased locally. Use only a metal adapter.
DO NOT
use plastic.
FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
Connect to household
plumbing
COLD
water valve
“Y” adapter
Make sure the “Y” adapter
valve is in the on position.
NOTE:
Use a metal “Y” adapter.
Do not use plastic
Connect to HOT water inlet
on washing machine
Connect to
COLD
water inlet
on washing machine
Disconnect the existing hose
from the HOT valve and washing
machine and remove. Replace with
optional stainless
steel hose. Part No.
49701-US
(not included).
Disconnect this stainless steel hose from
the
OUTLET
on your Laundry Pro 2.0, then
connect it to the “Y” adapter.
Connect the “Y” adapter to the
OUTLET
on your
Laundry Pro 2.0. Be sure to hold the fitting with
pliers while tightening the adapter.
Stainless steel hose supplied
with Laundry Pro 2.0.
