Beyerdynamic UNITE CR, Быстрый старт

Страница: 5 / 36

e
n
g
li
s
h
Unite CR – Cockpit Rack
5
Connection
• The equipment must be connected to a mains socket that has an earth contact.
• Protect the power cord by not walking or standing on it or pinching, this is considered for plugs especially
where they exit from the device.
• Lay all connection cables so that they do not present a trip hazard.
• Whenever working on the equipment switch off all inputs and outputs to the power supply.
• Check whether the connection figures comply with the existing mains supply. Serious damage could
occur due to connecting the system to the wrong power supply. An incorrect mains voltage could
damage the equipment or cause an electric shock.
• Please note that different operating voltages require the use of different types of power cable and plugs.
Please refer to the following table:
• If the equipment causes a blown fuse or a short circuit, disconnect it from the mains and have it checked
and repaired.
• Do not hold the mains cable with wet hands. There must be no water or dust on the contact pins. In both
cases you could receive an electric shock.
• The mains cable must be firmly connected. If it is loose there is a fire hazard.
• Always pull out the mains cable from the mains and/or from the equipment by the plug – never by the
cable. The cable could be damaged and cause an electric shock or fire.
• Do not use the equipment if the mains plug is damaged.
• If you connect defective or unsuitable accessories, the equipment could be damaged. Only use
connection cables available from or recommended by beyerdynamic.
Voltage Power plug according to standard
110 - 125 V UL817 and CSA C 22.2 no. 42.
220 - 230 V CEE 7 page VII, SR section 107-2-D1/IEC 83 page C4.
240 V BS 1363 (1984): “Specification for 13A fused plugs and switched and un-switched socket outlets.”