Beyerdynamic UNITE CR, Быстрый старт

Страница: 13 / 36

e
n
g
li
s
h
Unite CR – Cockpit Rack
13
4. In order to transfer the pairing information from the transmitter to the receivers in the slots and to the
charger itself for future pairing, press and hold the “Pair/Reset” button on the charger for more than
2 seconds. The status indicator will flash yellow for several seconds if the pairing is successful. The
status indicator will then remain yellow because the pairing information is now also stored in the
charger.
5. If you want to pair other receivers, remove the transmitter and all receivers from the charger, set the
switch to “Pair & Charge” and insert the unpaired receivers into the charger. The pairing information
will be stored immediately in the unpaired receivers. The status indicator on the receiver will flash yellow
rapidly while this happens.
6. Set the switch back to “Charge only” when the pairing is finished, so that the charger can only be used
for recharging.
7. Switch on the transmitter and one receiver to check that they have both been paired successfully.
After a few seconds, the status indicator on the receiver should light up green and the display should
show the channel name of the transmitter.
8.
If you want to clear the stored pairing information, hold down the “Pair/Reset” button for more than
five seconds. The status indicator will then remain permanently green.
9. Set the switch to “Charge only”, when no automatic pairing function is needed.