Bewacom Technical manual
15
Programming access codes
(first time)
Four different 4-digit entrance codes can be
programmed.
1
Set Bewacom to programming mode.
2 Press
0000.
3
Enter the desired access code using
4 digits.
4
Enter the code once again.
5
If the code is not to be time controlled,
press
0
.
If the code is to be time controlled,
select the desired input (see below).
1
= the code can be timed from a
time clock connected to input 1.
2
= the code can be timed from a
time clock connected to input 2.
Also see the wiring diagram on
page 10.
6
Follow steps 2-5 to programme the next
code.
7
Press B to exit programming.
