3. Dispense at least 3L of plain, still water into the bucket, discarding it
periodically until the water flows clear.
4. Remove the length of tube, reattach the outlet line, and dispense
another liter or so of water through the machine to ensure a clean flow
throughout.
Testing Water
Test each type of water - still, sparkling, and each flavor - testing for the
following:
●
Cool temperature (it will not be fully chilled yet)
●
Correct, noticeable, and enjoyable flavor
●
Sufficient CO
2
concentration
●
Consistent flow
If any of these seem off, consult the Bevi Hardware Guide or contact Bevi
Support at [email protected] .
Enter Incubation
IMPORTANT NOTE:
Incubation is a mandatory part of the installation
process. Without it, the Bevi temperature will be too high to properly
operate. Do not skip this step.
1. Once all components are properly connected and water is flowing
properly, close and lock the door of the Bevi.
2. In the service panel, press the Start Incubation button on the Other tab
at the bottom of the page.
3. Select the incubation time. We recommend 3 hours, but it can be set
lower if the carbonator has already been running for some time.
4. A screensaver with a countdown will appear. If you need to exit the
screensaver and return to the control panel, tap repeatedly between
the hours and minutes on the screen.
Bevi Support
Online: partners.bevi.co
Phone: 866-704-2384
© 2018 Bevi. All rights reserved. [email protected]