Beurer GL44 lean, Инструкция по эксплуатации

Страница: 20 / 40

20 Beurer GL44 lean
5.4. Post-processing and disposal
1
Remove the test strip from the device with the test strip ejection slider. Carefully dispose of the
test strip according to the currently applicable regulations to avoid infecting others.
2
Carefully remove the cap from the lancing device.
5
3
Place the retained protective disc flat on a hard surface. Stick the tip
of the needle into the protective disc so the needle is covered. Take
care not to touch the used lancet.
4
Use the sliding switch on the side. This causes the lancet to drop
out of the holder.
Carefully dispose of all blood samples and materials that came into
contact with you or your patient. Dispose of the lancet in a punc-
ture-proof container. This prevents injuries and the infection of others.
5 Place the cap back onto the lancing device.
5
5.5 Evaluating measured blood glucose values
Your blood glucose monitor can process measured values between 20 and 630 mg/dL (1.1 and
35.0 mmol/L). The “ ” warning is displayed for measured values below 20 mg/dL (1.1 mmol/L). The
“ ” warning is displayed for measured values above 630 mg/dL (35.0 mmol/L).
Warning
• If you suspect that the blood glucose results are incorrect, first repeat the test and, if applicable,
perform a functional test using control solution. Seek medical advice if dubious results persist.
• Immediately seek medical attention if your symptoms are not in line with your measured blood glu-
cose values and you have observed all instructions for the Beurer GL44 lean blood glucose moni-
toring system.
• Do not ignore symptoms of too high/low blood glucose levels. Consult your doctor.