18
Beurer GL44 lean
11
The device automatically switches on and shows the start display.
The device is ready to take measurements as soon as the hand and the droplet symbol
flash.
12
You may now use the lancing device to take a blood sample. Make
sure that the blood remains as a droplet and is not spread. Immedi-
ately use the blood droplet to take a measurement.
Blood sample from the fingertip
The best penetration areas are the middle finger and the ring finger.
Firmly position the lancing device slightly to the side of the centre of
the fingertip. Press the trigger. Remove the lancing device from the
finger. A round drop of blood of at least 0.6 microlitres (corresponds
to approx. 1.4 mm, original size:
) must have formed.
5
Please also note the following:
• If the blood glucose test results do not match how you feel, carry out another test using blood
from your fingertip.
• DO NOT change your treatment purely on the basis of a measurement that was carried out
using blood taken from an alternative area. Carry out another test with blood from your fin-
gertip in order to confirm the test result.
• If you often fail to notice that you have a low blood glucose level, carry out a test using blood
from your fingertip.
13
If there is an insu
ffi
cient amount of blood, repeat steps 1 to 12 with a greater penetration depth.
14
Hold the blood input gap (at the tip of the test strip) to
the drop of blood until the gap is completely filled and
the monitor in the display starts counting backwards. Do
not press the penetration area to the test strip. The blood
must not be spread. The blood is sucked into the gap.
Note
Error message “002” appears on the display if the gap was not correctly and su
ffi
ciently filled
with blood. Repeat the measurement using a new test strip and a greater penetration depth.
Note
• Do
not
apply blood to the sides of the test strips.
• Do
not
add blood later if the device does not start the measurement. Remove the test strip and end
this test. Use a new test strip.
• The device switches itself o
ff
if the test strip has already been inserted into the device but no blood
is added to the test strip within two minutes. Briefly remove the test strip and reinsert it so that the
device automatically switches itself back on.
• Contact Customer Services if you are unable to fill the test strip with blood correctly.
OK
Содержание GL44 lean
Страница 1: ...Instructions for use EN Code free BLOOD GLUCOSE MONITOR Step by step GL44 lean...
Страница 2: ......
