Bettis P/N 126858
Revision "F"
Page 12 of 15
5.2.2.2 Using pipe dope install the items assembled in step 5.2.2.1 into upper end cap
(10-10). NOTE: The pipe nipple (10-40) is installed into the upper end cap (10-10).
Position the above assembly such that the assembly will not interfere with the
center bar assembly (10-30).
5.2.3
Screw bottom end cap (10-60) onto center bar assembly (10-30).
5.2.4
Install reservoir o-ring (10-150) over the lip of bottom end cap (10-60).
5.2.5
Install cylinder (10-20) over the lip of bottom end cap (10-60).
5.2.6 Install reservoir o-ring (10-150) over the lip of upper end cap (10-10) then install entire
upper end cap assembly (10-10) over the lubricated center bar assembly (10-30) and into
the cylinder (10-20).
5.2.7
Install thread seal (10-80) and countersink washer (10-75) onto center bar assembly (10-
30).
5.2.8
Install and tighten acorn nut (10-70) onto center bar assembly (10-30).
5.2.9
Apply sealant to breather (10-140) and install into upper end cap (10-10).
5.2.10 Apply sealant to pipe plug (10-100) and install into bottom end cap (10-60).
5.3
M11 PUMP REASSEMBLY INSTRUCTIONS
NOTE: Review section 5.1 General Reassembly before proceeding with M11 pump reassembly.
5.3.1
Install o-ring seals onto two o-ring plugs (20-270).
5.3.2
Install one check valve (20-40), with o-ring seal into the bottom of pump rod (20-50).
5.3.3
Install one o-ring plug (20-270) into the bottom of pump rod (20-50).
5.3.4
Install one check valve (20-40), with o-ring seal into the side of manifold block (20-10).